Starlink on a standing-seam roof. No drilling, no parts from three catalogues.

No drilling into the roof — no voided roof warranty, no leak point. One part instead of three from three catalogues you have to match yourself. Built for the standing-seam metal roofs common across the Baltics, Nordics and DACH — Rheinzink, PREFA, NedZink and the Klassik profiles.

Standard270–550 mm seam step€149Order →XL550–600 mm seam step€249Built to your seam stepOrder →

The mount

FIG. 1 — SEAM CLAMP + PIVOT ARM (3D MODEL)DRAG TO ROTATE

CAD assembly — seam clamp, adjustable pivot arm, and standing tube. Drag to rotate, scroll to zoom.

Roof interface

Non-penetrating seam clamp — no drilling

Seam step (cover width)

270–550 mm, Standard model. 550 mm+ is the XL variant

Seam height

23–37 mm, measured working range — see note

Tilt adjustment

0–45°, locks under wind/snow load

Starlink Dish compatibility

Mini, Standard, Performance

Materials

galvanized steel

Tube diameter

42.4 mm

Install

One person, hand tools, ~20 min

Ships from

Europe

Seam height is the dimension most likely to rule a roof out. The 23–37 mm band is our own measured working range, not yet a figure confirmed by the clamp manufacturer — if your seam is near either end, send us a photo and a measurement before ordering.Does not include the Starlink dish-to-pole adapter — use the adapter that ships with your Starlink kit.

Which standing-seam roofs it fits

Standing seam is not one profile. The clamp grips the fold itself, so seam height decides fit before width does:

Fits — architectural / site-formed profiles

Rheinzink Doppelstehfalz — 400–550 mm seam step, 25 mm seam heightOutside: seam step 550–600 mm: XL variant
PREFA — 270–430 mm seam step, 25 mm seam height
NedZink — 430–550 mm seam step, 23–25 mm seam heightOutside: seam step 550–600 mm: XL variant
VMZINC — 270–550 mm seam step, 25–32 mm seam heightOutside: seam step 180–270 mm: too narrow
Klassik (Toode, Ruukki, Weckman, Plannja, Lindab) — 275–550 mm seam step, 25–37 mm seam heightOutside: seam step 550–600 mm: XL variant · seam height 38 mm: too tall for the clamp

The ranges above are what FalsMount supports, not the manufacturers' full catalogue ranges. A roof from one of these brands outside its range above is listed as outside.

Does not fit — industrial profiles

Kalzip — 305 / 400 mm seam step, ~65 mm seam height
BEMO N50 / N65 — 100–800 mm seam step, 50 / 65 mm seam height

These seams are roughly twice as tall as the clamp jaw opens. Width is not the problem — height is. We would rather tell you now than sell you a bracket that won't close.

Not sure which you have? Measure the distance between two seam folds (the step) and the height of the fold itself, then send both to hello@falsmount.com.

Choose your model →